Tools

The TAMS Laser Alignment Tool allows for easy alignment of the TAMS reference beam and sample beam.

Includes five different sizes.

For use with the Torion^® T-9 portable GC/MS.

For use with all PerkinElmer instruments with touchscreen controls. Package of 5.

For loosening upper seal.

For use with flow injection.

To connect the STS 25 to any general purpose 12 V battery power supply.

Includes cable clamp, 3-way plug cable mount, 12 V battery charger, and STS 25 installation assembly.

Rechargeable battery for use with STS-25.

The Combustion Tube Wrench is an 11 mm wrench made of aluminum. It is used to maintain PerkinElmer's Elemental Analyzer. It is also available as an 25 mm wrench.

Included in UHPLC (N2930801) HPLC Starter Kits (N2930802).

The Combustion Tube Wrench is an 25 mm wrench made of aluminum. It is used to maintain PerkinElmer's Elemental Analyzer. It is also available as an 11 mm wrench.

The Pin Vise for Micro Sample Handling securely holds small samples for FTIR sample preparation. It has a round, knurled steel handle with a grip range of 0-1 mm, ideal for separating thin fibers and films. Full-length holes allow the vise to accommodate wires of any length. The vise is a component of the Microsampling Tool Kit (N1870151). With this part number, it can be ordered as a replacement or spare.

The Micro Specimen Tweezers are made of stainless steel with a very sharp point on both arms of the tweezer to enable the precise handling of miniature and micro specimens. These tweezers come standard in the Microsampling Tool Kit (N1870151), but can be ordered with this part number as a replacement or spare set.

Non-magnetic.

These stainless steel straight forceps are hooked, non-magnetic, and non-serrated.

Used to open the Normally Open and Normally Closed Valves on EA 2400 Elemental Analyzers.

For use with a variety of modern AA Furnace Autosamplers, including the AS-800 and AS-900 installed on furnace equipped PinAAcle AA instruments.

The Retrieving Wire is used to remove tubes from the PE 2400 Series II Elemental Analyzer. It is a stainless steel rod, 19-3/16 in long and a diameter of 1/16 inches. It has a curved hook at one end to aid in grabbing and removing tubes from the analyzer.

The Straight Micro Probe is a straight stainless steel probe for infrared microspectroscopy. It comes standard in the Microsampling Tool Kit (N1870151).

For use with 1.2 mL sample cups.

Does not include lid.

The Microsampling Tool Kit includes:

• Forceps (N9302610)
• Roller Knife (N9302619)
• Tweezers (N9302609)
• Tungsten Needle (N9302604)
• Probe (N9302605)
• Handle tor Probe (N9302622)
• Pin Vise (N9302603)